Grid "save grid" option

Scriptcase 9 Bugs
#1

when I use “save grid state in session” with the settings

“save in session” = yes
“save mode” = manual
“Load the last saved session when starting the application” = yes

I get the following error message when using the option in the grid

grafik

grafik

grafik

Just felt like that, you never tested it, right?

#2

Hello, @salvatore

Can you indicate the steps needed to replicate the problem?

Following a standard way of saving, loading and clearing a state it was not possible to observe the error as seen below:

save_state
save_state1571×756 798 KB

#3

Hello, if i have 2 ore 3 saved views, how can i load one of this. I can’t see any options to select saved grids

#4

Hi Robert, how do you use the save state grid in the reload application? If I exit the application and run the application again how to launch the save filter as a default search?

#5

Hi Roberto,

Load the last saved session when starting the application is not working even with save state. When I load state is working but when I exit the application and start the same application, it does not load the save state.

#6

I get a similar message on the latest version when manually clicking Save State…

Its just an existing grid where I switched this on.

Its so obscure I have no idea how to fix and recreating the grid is a non-starter. I’ve switched it back off to avoid embarrassment with my customers.

Has anyone been able to replicate this and/or have any workarounds?

#7

Check your SQL hasn’t got embeded CRLF in it… That can cause the problems. It saves to the file with these embeded, then the apply grid thinks the CRLF is the end of the select.